Fixed up the carb. The air filter is supposed to be a fit straight on to the carb, but the diameter of the carb was at least 0.2 mm larger than the diameter of the filter. Had to file and sand until I could get it on. Then drilled and threaded the hole for the fastening bolt.
Then there was the dust cap for the needle adjustment. It was too large, so at full throttle it would be pushed out about a mm. Cut the cap also, so it would always be tight.
When that was done, I mounted everything together. It looks compact and nice when put together.
Then there was the dust cap for the needle adjustment. It was too large, so at full throttle it would be pushed out about a mm. Cut the cap also, so it would always be tight.
When that was done, I mounted everything together. It looks compact and nice when put together.
No comments:
Post a Comment